Pivot Doors
Oversized entrance leaves that turn on a concealed floor pivot instead of side hinges.
Look closer →
At a glance
- Typical sizes
- Anything from 700mm to 1400mm wide, up to 3000mm high
- Timber we use
- Walnut, oak, ash, smoked eucalyptus veneers over engineered core
- Lead time
- 7 to 10 weeks
- Supplied
- Leaf and frame together, machined for your hardware
What "designer" means here
A flush leaf with the ornament in the surface rather than in the moulding: brass or aluminium inlay strips, book-matched veneer, shadow reveals, routed shadow lines, or two timbers meeting on a diagonal. We build to the drawing rather than to a catalogue page.
Hardware planning
Concealed hinges, magnetic latches, flush pulls and floor springs are all machined at the mill, not on site. Send the hardware schedule with the drawing and the leaf arrives pre-morticed to the manufacturer template.
Matching a whole house
Most designer orders are a set: entrance, bedrooms, wet-area doors and sometimes wardrobe fronts. We batch the veneer from one flitch so the colour reads as one family across the project, and we hold the balance of the flitch for six months in case of later additions.
Specification
How we build it
The numbers below are our standard. Anything on this list can move if your drawing asks for something else.
- Core
- Engineered stile and rail with lightweight lattice or solid particle core
- Inlay
- Brass, blackened steel, aluminium or contrasting timber
- Machining
- Hardware routed to template at the mill
- Finish
- Two-pack PU in matt, satin or gloss; or natural oil
Also in the range
Doors that pair with these
Carved Doors
Hand-carved relief panels cut by craftsmen who have worked the same motifs for decades.
Look closer →
Solid Panel Doors
The classic stile-and-rail door in solid hardwood, with raised or flat panels.
Look closer →Tell us what the opening looks like
Send a photograph, a sketch on the back of an envelope or a full architectural set. You will get a costed shop drawing back, not a brochure.