First, we stop the water
On an emergency call the first ten minutes matter more than the next two hours. We guide you over the phone to the right stop valve while the van is moving, so damage stops climbing before we even arrive. Once on site we isolate the affected line rather than shutting the whole house down where possible, which means the rest of your taps keep working while we repair.
Then we find the real source
A wet patch on the ceiling is rarely below the leak. Water travels along conduits, beams and pipe runs, and opening the wrong section of plaster just adds a repair bill. We use moisture meters and thermal readings to narrow the leak down before any hacking, and we show you the readings so you can see why we are opening a particular spot.
Repairs that do not come back
Malaysian homes mix decades of materials: old galvanised iron, poly pipe from the nineties, modern PPR and PEX. Each joins differently, and most "repeat leaks" we see are a previous repair that mixed materials badly or relied on tape. We carry fittings for all common systems, replace the failed section back to sound pipe, and pressure-test before closing anything up.
Typical jobs in this category
- Burst or split pipes, including inside walls and above ceilings
- Dripping taps, mixers and shower valves, repair or replacement
- Leaking toilet inlets, flexible hoses and stop valves
- Ceiling stains and damp walls traced and resolved
- Water tank overflow and float valve faults
- Leaking external standpipes and garden lines
What it costs
Simple tap and valve repairs usually land between RM120 and RM280 including parts. Pipe repairs vary with access, so we quote after seeing the site, always in writing and always before work starts. If you approve the quote, the inspection is free within our core coverage area.
Stop the damage today
Fixed written quote before any work. Most leak repairs done in a single visit.